Today I had to draw 12" square piles along a shore line about 100 feet long at 3' centers. The shore line was obvious not in a straight line. Originally I was going to draw my square with a circle with a 3' radius and copy each object one at a time. I would use the center of the square (and circle) as a base point and place the next object at the intersection of the circle and the shoreline. Tedious, but it would get the job done. Then I thought about it for a second. there has to be a way to do this in one (maybe two) keystrokes. So I went to the discussion boards at AUGI.
The great people there suggested I use either the DIVIDE or MEASURE command. I always forget about those two commands. Not any more! Both commands work virtually the same. They will place points along a selected line (polyline or spline) in equal segments. DIVIDE places a number of points along a line (a number you give it) while MEASURE places points along the line at a set interval (provided by you.)
If you don't want to place the points, you can choose to place a block instead. In this case (as it was suggested to me on the AUGI discussion boards) I made my pile a block and had the measure command insert it along my polyline at 3' intervals. AND (yes it gets better!) when I did this, the command asked me if I wanted the blocks to be aligned with the line! Of course I did!! Boo-ya!!! What was going to take me 5 minutes to do, now took 30 seconds (not counting the time spent on the board.)
Thanks AUGI!
